1. First treat the base surface and polish it thoroughly without any attachments. Then roll on the carbon fiber leveling glue, correct the misalignment, and apply the ink line.
2. Then roll the carbon fiber impregnation glue on the bonding surface, and the glue amount must be sufficient and full. Then stick the cut carbon fiber cloth on the concrete coating surface, and the carbon fiber cloth should be straight and taut.
3. Then roll the carbon fiber impregnation glue on the carbon fiber cloth to ensure that the surface of the carbon fiber cloth is completely covered and the fibers in the carbon fiber cloth are fully infiltrated. And use a scraper to repeatedly roll the carbon fiber cloth to make the carbon fiber cloth straight, taut, and bubble-free, and the carbon fiber glue is fully penetrated.
4. Then roll on the carbon fiber impregnation glue to make it penetrate, and use a scraper to repeatedly scrape and defoam. Finally, spray 3-6mm sandstone (quartz sand) on the construction surface coated with glue to ensure the adhesion of the plaster layer.
